Micromod Micro-DCI: 53ML5100 Manual Loader - Manual (Page 38)

53ML5100B Manual Loader
INSTRUCTION MANUAL
Table 4-5. Display Module
Purpose: This module is used to define the number of displays (six maximum) and to set the display order
presentation of the operator displays. The default settings are for six displays in the order shown in Figure 1-1 and
listed as follows:
1. Dual Channel Manual Loader (Chs. 1&2)
2. Single Channel Manual Loader (Ch. 1)
3. Manual Loader with Analog Input (Ch. 1)
4. Manual Loader with Analog Input (Ch. 2)
5. Analog Input Indicator with Setpoint Display (Ch. 1)
6. Analog Input Indicator with Setpoint Display (Ch. 2). Displays can be listed in any order and less than six can be
specified, for example, for a single channel configuration: B018 = 3 (three displays), B021 = 3, B022 = 5, and B023
= 2. The displays will advance from display number 3, to display number 5, to display number 2 each time the F2
push button is pressed. Pressing the F2 push button a fourth time repeats the cycle with display 3 again.
Title Symbol
Datapoint
Default Attribute
Number
of
Displays MDS B018 6 specifies the total number of operator displays that are presented
each time the 2 push button is pressed before the cycle repeats
itself beginning with the first display number selected. The
maximum number is 6.
Display 1 B021 1
Display 2 B022 2
Display 3 B023 3
Display 4 B024 4
Display 5 B025 5
Display 6 B026 6
Each datapoint is loaded with a display number from the list above
to set the display presentation order.
34