Micromod Micro-DCI: EP1000A E-Port User Manual
Instruction manual
Table of contents
Document Outline
- 1.0 Introduction
- 2.0 Installation
- 2.1 Inspection
- 2.2 Location
- 2.3 Mounting
- 2.4 Connections
- 2.4.1 Power Connections
- 2.4.2 Data Connections
- 2.4.2.1 Connecting to a 53SL6000 Controller
- 2.4.2.2 Connecting to the Front Port of an MC5000 Unit
- 2.4.2.3 Connecting to an RS-485 ITB
- 2.4.2.4 Connecting the RS485 ITB to Micro-DCI Controllers
- 2.4.2.5 Connecting to a MOD30ML using RS-232
- 2.4.2.6 Connecting to MOD30MLs using 4 wire RS-485
- 2.4.2.7 Connecting to a MODCELL using RS-232
- 2.4.2.8 Connecting to MODCELLs using 4 wire RS-485
- 2.4.3 Ethernet Network Connection
- 3.0 Micro-DCI Software Configuration
- 3.1 Creating an E-Port Network with Super32
- 3.2 Configuring the E-Port
- 3.2.1 Getting Started
- 3.2.2 Configure the E-Port Unit Settings
- 3.2.2.1 Configuring the E-Port Unit IP Address
- 3.2.2.2 Configure E-Port Unit Parameters
- 3.2.2.3 Assign Device Information to the E-Port Unit
- 3.2.2.4 Configure Serial Port/Network Settings for the E-Port Unit
- 3.2.2.5 Recording Information onto the E-Port Label
- 3.2.2.6 E-Port Configuration Security
- 3.2.2.7 How to Choose an IP Address
- 3.3 Network Management
- 4.0 XModbus OPC Server Configuration
- 4.1 Creating an Ethernet Port
- 4.2 Creating a Device
- 4.3 Configuring the E-Port
- 4.3.1 Getting Started
- 4.3.2 Configure the E-Port Unit Settings
- 4.3.2.1 Configuring the E-Port Unit IP Address
- 4.3.2.2 Configure E-Port Unit Parameters
- 4.3.2.3 Assign Device Information to the E-Port Unit
- 4.3.2.4 Configure Serial Port/Network Settings for the E-Port Unit
- 4.3.2.5 Recording Information onto the E-Port Label
- 4.3.2.6 E-Port Configuration Security
- 4.3.2.7 How to Choose an IP Address
- 4.4 Network Management
- 5.0 Maintenance