Micromod Micro-DCI: EP1000A E-Port - Manual (Page 5)

EP1000A E-Port Instruction Manual
Introduction 1
1.0 Introduction
1.1 Product Overview
The MicroMod Automation EP1000A E-Port product provides an interface between the serial networks
used by MicroMod controllers and an Ethernet network.
E-Ports with Rev. 0 firmware support the Micro-DCI Datalink protocol and can be used with Micro-DCI Sys-
tem Version 4.1 software products
E-Ports with Rev. 1 firmware support both the Micro-DCI Datalink and MicroMod Extended Modbus.and
are compatible with Micro-DCI System Version 4.2 and MOD System 3.2 software products
1.2 Scope of Book
Information in this book is presented as text, visuals, and tables. All three are required, but the text has
been minimized wherever possible. The tables provide either summary information or procedural steps to
perform a specific task.
The sections of this book contain the following information:
• Section 1, Introduction : This section contains basic product and book information as well as
the product specifications.
• Section 2, Installation : This section provides mounting information, power wiring instructions,
and signal wiring instructions.
• Section 3, Micro-DCI Software Configuration : This section describes how to configure the
Micro-DCI Communications services to work with the EP1000A.
• Section 4, XModbus OPC Server Configuration : This section describes how to configure the
MicroMod XModbus OPC Server to work with the EP1000A
• Section 5, Maintenance : This section provides trouble-shooting and information for the E-Port
interface box. It also includes the parts list.