Micromod Micro-DCI: EP1000A E-Port - Manual (Page 17)

EP1000A E-Port Instruction Manual
Installation 13
2.0 Installation
2.1 Inspection
An itemized list of all items in the shipment is attached to the shipping container. Inspect the equipment
upon arrival for damage that may have occurred during shipment. All damage claims should be reported to
the responsible shipping agent before installation is attempted. If damage is such that faulty operation is
likely to result, the MicroMod Automation Service Department should be notified.
Inspect the packing material before discarding it as a precaution to prevent loosing mounting hardware or
special instructions that may have been included with the shipment. Normal care in the handling and instal-
lation of this equipment will contribute toward its satisfactory performance.
2.2 Location
The E-Port interface unit is designed specifically for indoor mounting. The installation site selected should
be dry and vibration free. The ambient temperature should be stable and maintained within the specified
minimum and maximum temperature limits listed in
Section 1.4, Specifications , of this Instruction Manual.
Power requirements are provided in Section 1.4, Specifications .
2.3 Mounting
2.3.1 General
It is normally not necessary to open the E-Port interface unit during installation. If the case of the unit must
be opened, refer to
Section 5 for details. Incorrect procedures may damage the unit.
A number of mounting options are available for the E-Port interface unit. These include:
• Wall-mounting (brackets)
• DIN Rail mounting (plastic clips)
• Snap Track mounting (bracket)
Appropriate mounting hardware is supplied by MicroMod Automation Inc., as identified in the product
model number.