MaxPower Corp Gamatronic Power+ SA - Manual (Page 51)

Gamatronic Electronic Industries Ltd.
8. FIRST-TIME SETUP
8.1 Cable Connections
Only an authorized electrician may wire the UPS power connections.
Do not attempt to wire any of the power connections on your own.
U
SE REQUIRED WIRING SIZE ACCORDING TO
THE N ATIONAL E LECTRIC C ODE , NSI/NFPA 70 ( IN THE U.S.),
OR THE C ANADIAN E LECTRICAL C ODE , S ECTION 54 ( IN C ANADA ).
E MPLOYEZ REQUIS EN CABLANT LA TAILLE SELON
LE C ODE É LECTRIQUE N ATIONAL , NSI/NFPA 70 ( DANS É TAS -U NIS )
OU LE C ODE E LECTRIQUE C ANADIEN , S ECTION 54 ( DANS C ANADA ).
To connect the required cables to the UPS:
1. Verify that only cables rated in accordance with the values shown in Table 15-1
on page 66 are used.
2. Verify that all power lines coming into the P OWER + SA have circuit breakers
rated according to the values shown in Table 15-3 on page 66.
3. Using a Phillips screwdriver, remove the cable cover from the rear of the
P
OWER + SA.
4. Connect the input and output electrical cables as described in section 15.3.2
“Installing the P
OWER + SA” beginning on page 68.
Be sure the wires are not live before you begin.
Ensure that the proper phase order is followed.
5. After connecting the cables, recheck your work to verify that the cables and
their wires are connected to the proper terminals.
POWER+ SA User Guide (UL), Release 1.0 45