Magnum Venus Plastech INNOVATOR MEGAJECT 5000 (8001) - Manual (Page 31)

MAGNUM VENUS PLASTECH Innovator Megaject Manual 31
FIRST TIME START-UP CHECK LIST
INNOVATOR MEGAJECT
ACTIVITIES MUST BE DONE IN THE SEQUENCE SHOWN, AND MUST BE TICKED
OFF AS COMPLETED. THIS SEQUENCE FOLLOWS ON FROM “PRE-START
CHECKLIST INNOVATOR MEGAJECT”
ACTIVIT
Y NO.
ACTIVITY TICK
WHEN
COMPLET
ED
Priority Put on Respirator as specified for spray painting, Protective
Clothing, Eye Protection, and PVC Gloves
1 Turn the pump regulator to zero
2 Adjust the catalyst percentage required with the slide arm Knob.
3 With all the material containers properly filled. Press the
Recirculation Button on the control panel.
4 Slowly increase the pump regulator so that the pump strokes
slowly and evenly.
5 Allow the pump to recirculate until the flow of Resin and Catalyst
back to there respective containers is free of bubbles.
6 Press the Stop button to take the unit out of recirculation mode
7 Test the catalyst and resin to the Injection head – Place a
suitable container under the injection head and press the Inject
button. After 4 or 5 strokes press the Stop button.
8 Check that the material properly cures
9 Properly dispose of the catalyst and resin.
10 Flush the Injection head as necessary into the appropriate
container.
ABNORMAL CONDITIONS OBSERVED AND CORRECTED
Abnormal Condition a a a a when
corrected
OPERATORS NAME ________________________________ DATE: ____________
SIGN OFF WHEN START UP CHECKS ARE COMPLETED: _______________________