Magnum Venus Plastech INNOVATOR MEGAJECT 5000 (8001) - Manual (Page 16)

MAGNUM VENUS PLASTECH Innovator Megaject Manual 16
1. Unpack unit & components
2.
Install the Catalyst pump onto the Slave Drive assembly.
3.
Mount the Catalyst Jug Bracket
4.
Install Catalyst Jug into the Catalyst Jug Bracket
5.
Attach Catalyst Feed tube between the Catalyst Jug outlet and Catalyst
pump Inlet – trim the Feed tube as necessary to keep it always flowing up to
the Catalyst Jug outlet.
6.
Install the Catalyst leak control tube from the top of the Catalyst Pump to the
port in the Catalyst Jug.
7.
Connect the Catalyst Hose from the Catalyst Pump outlet to the Injection
head.
8.
Attach Pickup Hoses to the inlet of the pump
9.
Place Flush Tank in holder and attach air hose. Connect yellow Flush Tube
from Injection Head to Flush Tank.
Note: Be sure the Flush Tank connections are correct or the Equipment will
be damaged. It is important not to fill the Flush Tank more then 3/4 full or
solvent can get in the air system and cause damage.
Double check all hose fittings and connections are tight
The repair and maintenance of several components will require the use of
removable Loctite® 243 or equivalent thread lock compound, Lithium grease
(Lubriplate 08465) and Red Grease (6706-2-1).