Liquid Controls HML4-F1 - LCMag - Manual (Page 3)

HML4-F1
3
INTRODUCTION
These operating instructions and description of device functions are provided as part of the
scope of supply. They could be modified without prior notice. The improper use, possible
tampering of the instrument or parts of it and substitutions of any components not original,
renders the warranty automatically void.
The converter is to be used only to be coupled directly with a sensor device to realize a
measuring device, flow meter, that is to be used for measuring the flow of conductive
liquids in closed pipes with conductivity greater than 5µS/cm.
The reproduction of this manual and any supplied software is strictly forbidden.
SAFETY INFORMATIONS
Any use other than described in this manual affects the protection provided by the
manufacturer and compromises the safety of people and the entire measuring system and
is, therefore, not permitted.
The manufacturer is not liable for damaged caused by improper or non-designated use.
1) Transport the measuring device to the measuring point in the original packaging. Do
not remove covers or caps until immediately before installation. In case of cartons
packaging it is possible to place one above the other but no more than three cartons.
In case of wooden packaging do not place one above the other.
2) Disposal of this product or parts of it must be carried out according to the local
public or private waste collection service regulations.
3) The converter must only be installed, connected and maintained by qualified and
authorized specialists (e.g. electrical technicians) in full compliance with the
instructions in these Operating Instructions, the applicable norms, legal regulations
and certificates (depending on the application).
4) The specialists must have read and understood these Operating Instructions and
must follow the instructions it contains. The Operating Instructions provide detailed
information about the converter. If you are unclear on anything in these Operating
Instructions, you must call the service.
CONVERTER SENSOR