CNB IPM3063P - Manual (Page 8)

◎ LAN Connection
- Multiple Connection
.
◎ SD CARD
- When the alarm input and Motion detection occurred, image save memory.
- SC Card is not provided in this product’s package. (512K~4G Bytes)
◎ UPGRADE
- Speed Dome Firmware Upgrade (Using Update Stick)
- This function is not supported now.
◎ Before connecting sensors, check driving voltage and output signal type of the sensor.
Since output signal types of the sensors are divided into Open Collector and Voltage
Output type in general, the cabling must be done properly after considering these
typed.
◎ If you want to use Alarm Input, the types of sensor must be selected in OSD menu.
The sensor types are Normal Open and Normal. If sensor type is not selected properly,
the alarm can be activated reversely.
Sensor Input Cabling
15 14
Signal Description
COM+
Connect (+) cable of electric power sources for Sensors to this port
as shown in the circuit above.
IN1-, IN2-,
IN3- , IN4- Connect output of sensors for each port as shown in the circuit
above.
Description Type
Normal Open Output Voltage is high state when sensor is activated
Normal Close Output Voltage is high state when sensor is not activated
Internal Circuit
+ -
+ -
IN 1-
IN 4-
Sensor Output 1
Sensor Output 4
IN COM+
+5V ~ 12V
LAN
#1 #2 #n
ROUTER INTERNET
LAN LAN
Web Viewer / CMS