Configuring and operating ptz, Configuring motion detection area – CNB IPM3063P User Manual
Page 28
◎
This defines areas that detect motion and up to three different areas can be defined
in each channel.
Click [Motion] button in Administrator and Operator mode to open the page shown
in below figure.
Configuring and operating PTZ
55
54
Configuring Motion Detection area
Preset/Pattern/Swing/Group operation are stopped.
Desired Group is executed.
-
Desired Swing is executed.
-
Run pattern.
Save and Stop pattern.
Start pattern recording.
The camera moves to the specified Preset position.
go
Current preset NO. is deleted.
del
The current position is set to Preset No.
set
Iris- : Executes Iris Close.
Iris+ : Executes Iris Open.
Iris-/Iris+
Near : Executes Focus Near.
Far : Executes Focus Far.
Near/Far
Tele : Executes Tele zoom.
Wide : Executes Wide zoom.
Tele/Wide
Moves camera up/down/left/right.
Moves Origin.
Direction Key
DESCRIPTION
ITEM