CNB IPM3063P - Manual (Page 25)

• When SD Card removes, disable the Event.
◎ This configures XPEED-XNET’s Event Types.
Click [Event Types] to view page shown in below figure.
Configuring Event Type
49 48
Recalls previously saved configurations. - Reset
Applies and saves changes. - Save
This allows Alarm images to be saved in the external memory (SD Card) .
SD card has to be properly installed and recognized for this feature. Save Image to
SD Memory
This allows Alarm images to be saved in the internal memory.
Saved image can get transferred to the client’s PC by using save image
button at system configuration page.
Save Image to
Internal Memory Select
Storage
This allows Alarm images to be sent out by an e-mail when processing
an event. Only one image file at the moment of the event gets sent out.
The e-mail address has to be accurately entered and saved at SMTP
configuration page.
Send Image to
Email
This allows Alarm images to be uploaded to an FTP server when
processing an event. The client PC has to run FTP server to receive the
Images and the information of the FTP server has to be accurately
Entered and saved at the FTP Configuration page.
Upload image to
FTP
Event
Output
Specify schedule for Event (Alarm) monitoring. Event (Alarm) is
monitored according to the schedule specified here. Event
Schedules
Setting
Enables or disables scheduled event monitoring.
When always is selected while Event (Alarm) is activated, the unit will
monitor event (Alarm) all the time.
During Time is selected while Event (Alarm) is activated, the unit will
monitor event (Alarm) during the time period specified.
Event
Schedules
Event Schedules
When processing an event, this establishes saving images after the
occurance of the event.
It can be between 1 and 8 seconds after the event, and the number of the
images to be saved gets determined by the Capture Frame rate.
Post-Alarm
When processing an event, this establishes saving images before the
occurance of the event.
It can be between 1 and 5 seconds before the event, and the number of
the images to be saved gets determined by the Capture Frame rate.
Pre-Alarm
When processing an event, this establishes the number of images to be
saved per second. It can be selected between 1 and 3.
Capture Frame
Event Setting
Enables or disables Motion Detection. Motion
Detection
Enables or disables the Alarm sensor. Sensor
Event Mode
Enables or disables event processing. Enable Event Event Enable
DESCRIPTION ITEM