CNB IPM3063P - Manual (Page 37)

•
• SWING NO. [1~8]
- Selects Swing number to edit. If a selected Swing
has not defined, "NOT USED" is displayed in 1st
Position and 2nd Position.
• 1st POS, 2nd POS [PRESET 1~128]
- Set up the 2 position for Swing function.
If a selected preset is not defined, "UNDEFINED“
will be displayed as shown below.
◎ When swing function runs, camera moves from the preset assigned as the 1st point
to the preset assigned as the 2nd point in CW (Clockwise) direction. Then camera
moves from the preset assigned as the 2nd point to the preset assigned as the 1st
point in CCW (Counterclockwise) direction. In case that the preset assigned as the 1st
point is same as the preset assigned as the 2nd point, camera turns on its axis by
360
° in CW direction and then it turns on its axis by 360° in CCW direction.
• SWING SPEED [1 °/sec ~ 180°/sec]
- Sets Swing speed from 1°/sec to 180°/sec.
• CLEAR SWING [CANCEL/OK]
- Deletes current Swing data.
• PATTERN NO. [1~4]
- Selects Pattern number to edit.
If a selected pattern number is not defined,
"UNDEFINED" will be displayed under selected
pattern number.
• CLEAR PATTERN [CANCEL/OK]
- Deletes data in current pattern.
• EDIT PATTERN
- Starts editing pattern.
◎ Using direction keys, move to start position with appropriate zoom. To start pattern
recording, press NEAR key. To exit this menu, press FAR key.
◎ Move camera with the direction key or run preset function to memorize the path
(mostly curve path) in a selected pattern. The total memory size and the rest memory
size is displayed in the form of bar. Maximum 1200 communication commands can be
stored in a pattern.
◎ To save data and exit, press NEAR key. To cancel recording and delete record data,
press FAR key.
• GROUP NO. [1~8]
- Selects Group number to edit.
If a selected Group number is not defined,
"UNDEFINED" will be displayed under selected
Group number.
• CLEAR GROUP [CANCEL/OK]
- Deletes data in current Group.
• EDIT GROUP
- Starts editing Group.
SWING SETUP
PATTERN SETUP
EDIT PATTERN
GROUP SETUP
NEAR
SWING SETUP
SWING NO .
2ND POS .
BACK
EXIT(MENU OFF)
1
NOT USED
NOT USED
SWING SPEED
CLEAR SWING CANCEL
1ST POS .
30 /SEC
☞
PATTERN SETUP
PATTERN NO .
CLR PATTERN
BACK
EXIT(MENU OFF)
1
UNDEFINED
CANCEL
>
☞
EDIT PATTERN 1
MOVE TO START POSITION
[NEAR :START /FAR :CANCEL ]
GROUP SETUP
GROUP NO .
CLEAR GROUP
BACK
EXIT(MENU OFF)
>
☞
SWING SETUP
SWING NO .
2ND POS .
1
PRESET 5
NOT USED
1ST POS . ☞
UNDEFINED
EDIT PATTERN 1
[NEAR :SAVE /FAR :DELETE ]
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
0 /0 /x1/N
73 72