CNB IPM3063P - Manual (Page 20)

◎ This is related to XPEED-XNET’s DDNS server information.
Click [RTP/RTSP] button to open the page shown in below figure.
Configuring Video
39 38
Configuring RTP/RTSP
Recalls previously saved configurations. - Reset
Applies and saves changes. - Save
Select sub stream video quality between 10 and 100. Quality
MJPEG
Appearance
Select Frame rate of sub stream video between 1 and 15 frames per
second
Frame rate
Frame Rate
Control
Select resolution of sub stream video between D1 and CIF. Resolution Sub Stream
Selects bit rate for MPEG4 or H.264 video signal between 128kbps and
3Mbps.
Bit rate
Mpeg4&H.264
Appearance
Select MJPEG’s video quality between 10 and 100. Quality
MJPEG
Appearance
Selects Frame rate of Video output.
1~30 Frame .
Frame rate
Frame Rate
Control
Turn Sub Stream feature on or off.
Sub Stream output is in MJPEG with maximum 15 frame per second.
When configuring, select main Stream or Sub Stream in the index page.
“Enable Dual-Codec checkbox” is enabled when Codec is set
Up as MPEG4 or H.264.
Enable
Dual-Codec
Selects Video Codec.
You can choose among MJPEG, MPEG4 and H.264.
Codec
Select a resolution of the video image.
D1, CIF(320x240)
Resolution
Main Stream
DESCRIPTION ITEM
Recalls previously saved configurations. - Reset
Applies and saves changes. - Save
Enter the maximum allowable number of users connected to the
Stream between 1 and 10. Maximum
number of
Connection
Enter RTP End Port between 1124 and 65535. The default is 3000. RTP End Port
Enter RTP Start Port between 1024 and 65534. The default is 2000. RTP Start Port
RTP
Configuration
Enter RTSP Port of the Sub Stream between 1 and 65535.
The default is 665. Multiple-RTSP
Port
Enter RTSP Port of the Main Stream between 1 and 65535.
The default is 554.
RTSP Port
RTSP
Configuration
DESCRIPTION ITEM