INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 6)

6
Logging In
Follow these steps to configure this switch.
Step 1: Use Ethernet Cat5 cable to connect this switch to your PC.
Step 2: Check that your PC has an IP address on the same subnet as the switch. For example, the PC and the
switch are on the same subnet if they both have addresses that start 192.168.1.x. The subnet mask is
255.255.255.0.
Step 3: Open the browser (such as Microsoft Internet Explorer) and go to http://192.168.1.1, which is the
switch address. If your PC is properly configured, you will see the login page below:
Figure 2: Login Popping Up Window
NOTE: If you do not see the login page, check that Steps 1 and 2 were done correctly.
Step 4: Key in both the default user name “admin” and the password “admin” to pass the authentication. After
the authentication procedure, the switch is operational and the interface menu below should display.