INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 40)

40
Bandwidth Control Setting
This function allows the network manager to control the maximum rate for traffic received on a port or
transmitted from a port. Rate limiting is configured on ports at the edge of a network to limit traffic into or out of
the switch. Packets that exceed the acceptable amount of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface is configured with this feature, the
traffic rate will be monitored by the hardware to verify conformity. Non-conforming traffic is dropped;
conforming traffic is forwarded without any changes. Input and output rate limits can be enabled or disabled for
individual interfaces.
Web Smart switch interface
To configure bandwidth control:
1. Click Configuration, Bandwidth Control.
2. Select the ports to configure.
3. Set Type to Ingress or Egress.
4. Set State to Enable.
5. Configure the maximum rate allowed on the ports.
6. Click Apply.
Figure 29: bandwidth control
Hint
The following parameters are shown on the Bandwidth Control screen:
■ Port - Display the port/trunk number.