INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 33)

33
■
Weight-round-robin - Share bandwidth at the egress ports by using the scheduling weights for queues 1
through 8, respectively. WRR specifies a relative weight for each queue that determines the percentage of
service time the switch services each queue before moving on to the next queue.
■ Queue ID - Output queue buffer. (Range: 1-8, where 8 is the highest-priority queue)
■ Weight - Set a new weight for the selected traffic class. (Range: Strict or 1-15)
Use queue weights 1-15 for queues to allocate service time based on WFQ or WRR. Queue weights must be
configured in ascendant manner, assigning more weight to each higher-numbered queue.
Strict priority requires all traffic in the queue to be processed before lower-priority queues are serviced.
LLDP Configurations
LLDP is a Layer 2 protocol that uses periodic broadcasts to advertise information about the sending device.
Web Smart switch interface
To configure global and port settings for LLDP:
1. Click Configuration, LLDP, LLDP Settings.
2. Enable LLDP for the switch.
3. If required, modify other LLDP parameters.
4. For one or a group of ports, set the LLDP mode.
5. Click Apply.
Figure 24: LLDP Settings
Hint
The following parameters are shown on the LLDP Settings screen.
■ LLDP Status - Enable LLDP on the switch. (Default: Disabled)