INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 11)

11
Figure 8: Port Setting
Hint
The following parameters are displayed on the Port Setting configuration screen:
■ Port—Lets you set up one or more ports. Hold down the CTRL key and click port numbers to select multiple
ports. Hold down the SHIFT key to select a range of ports.
■ State— Lets you set the link state of port interfaces. (Default: Enabled)
■ Speed/Duplex—Configures the port speed and duplex mode using auto-negotiation or manual selection.
(Default: Auto-negotiation enabled)
■
Auto - Enables auto-negotiation. When using auto-negotiation, the optimal settings will be negotiated
between the link partners based on their advertised capabilities. Auto must be enabled for all 1 Gbps
connections.
■
100M/Full - Supports 100 Mbps full-duplex operation.
■
100M/Half - Supports 100 Mbps half-duplex operation.
■
10M/Full - Supports 10 Mbps full-duplex operation.
■
10M/Half - Supports 10 Mbps half-duplex operation.
■ Flow Control—Displays the following:
■
Config – The configured flow control mode of the port.
■
Actual – Indicates the link status of the port. When a link is up, indicates the operating flow control mode.