INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 44)

44
Power over Ethernet Setting
Power over Ethernet (PoE) means that power-sourcing equipment (PSE) supplies power to powered devices (PD)
such as IP telephones, wireless LAN access points and Web camera from Ethernet interfaces through twisted pair
cables.
Web Smart switch interface
1. Click Configuration, Power over Ethernet.
2. Select the port number of the connected PD.
3. Specify the PD on.
4. Click Apply.
Figure 32: Power over Ethernet
Hint
The following parameters are shown on the Power over Ethernet screen:
■ PD - Enable the powered devices. The consumption power in Watts will be shown in the table below.
■ Class - Indicates the PD classification.
■ Consumption Power (W) - Indicates the PD power consumption.
Once the PSE has detected the PD’s power class, the PSE can manage the power allocation by subtracting the
PD’s class maximum value from the overall power budget. This allows for control and management of power
allocation when there is not enough power available from the PSE to supply maximum power to all ports.