INTELLINET NETWORK 560559 16 Ports Gigabit + 2 Gigabit SFP PoE+ Web Management Ethernet Switch User Manual - Manual (Page 32)

32
Packet Scheduling Setting
You can set the switch to service the queues based on a strict rule that requires all traffic in a higher-priority
queue to be processed before lower-priority queues are serviced. Weighted Fair Queuing (WFQ) or Weighted
Round-Robin (WRR) queuing specifies a relative weight of each queue. The traffic classes are mapped to one of
the eight egress queues provided for each port. You can assign a weight to each of these queues (and thereby to
the corresponding traffic priorities). This weight sets the frequency at which each queue will be polled for service,
and subsequently affects the response time for software applications assigned a specific priority value.
Web Smart switch interface
To configure port-level DSCP remarking:
1. Click Configuration, QoS, Packet Scheduling.
2. Select the scheduling algorithm, WFQ or WRR.
3. Map scheduling weights to a queue ID, or select “Strict.”
4. Click Apply.
Figure 23: Packet Scheduling Setting
Hint
The following parameters are shown on the DSCP-based Priority Setting screen:
■ Scheduling Algorithm - Select the service method used for port egress queues.
■
Weight-fair-queue - Service the egress queues containing data based on the weight of the queue compared
to the sum of the weights of all queues. (This is the default selection.)