Clear-Com Concert for Newsroom - Manual (Page 15)

15 Concert ActiveX Client for ENPS User Guide
2. The Concert login screen is displayed. Do either of the following:

Before you log in, click the configuration icon [ ]. Go to Config > Audio.

Log into Concert. Click the configuration icon [ ] in the side bar. In the
configuration dialog, select Audio.
Notes:
For more information about logging into Concert, see 2.1 Login.
Simple mode is pre-selected in the Audio dialog.
3. In Network Settings, select the type of network connection that best describes your
network (the default setting is WAN).
Select from the following types of network connection:
Network
connection
Description
LAN Concert is used on a corporate LAN (same office). High and
stable bandwidth. High audio quality but more bandwidth is used.
WAN Default setting. Concert is used on a corporate WAN (controlled
network environment). Bandwidth may be lower between two
offices or sites.
Internet Concert is used on the Internet (at home or a remote site).
Bandwidth is uncontrolled, unstable and low. Less bandwidth is
used.
Table 3: Audio: Network Settings (Simple mode)
4. In Network Settings, you also have the option to change your network settings for the
Eclipse Network.
To change the default setting, deselect Get Eclipse Network from server (default).
From the drop-down list, select the appropriate setting (LAN, WAN or Internet).
Note:
To see if your system is enabled for Eclipse, the digital matrix system from
Clear-Com, go to Config > Server > Advanced mode. Eclipse parameters cannot be
edited. The parameters are set in the Concert Management Interface (CMI) by your
system administrator.
For more information, see 1.3 Configuring the Concert Server.