Clear-Com Concert for Newsroom - Manual (Page 19)

19 Administrator Guide
4.4.2 Adding and removing an Interface Gateway node
Important Note:
Only create an Interface Gateway node if you have Clear-Com supported audio hardware installed on
one of your Concert servers.
To add an Interface Gateway node:
1. Navigate to System > Node > [node_name] and click on Interface Gateway within the
navigation tree. The Interface Gateways page is displayed.
2. Within the Interface hostname field, type the hostname of the Interface Gateway.
Note:
You cannot modify a hostname once an Interface Gateway has been created. The Interface
Gateway must be deleted and recreated to change the hostname.
3. Optional: In the Description field, type a brief description of the Interface Gateway
(for example, Local 4-Wire Interface).
4. Click [add]. The Details page is displayed.
5. The Base Management Port is the port used by the EMS to manage the Interface Gateway.
Clear-Com recommends that you accept the default value of 8009 for the Base Management
Port.
Note:
If choosing a Base Management Port other than 8009, refer to the Concert Installation Guide
for detailed guidance on modifying port usage.
6. In IV-Router, select the IV-R. The first IV-R detected is pre-selected in the drop-down menu.
Note:
Selection of an IV-R is mandatory.
7. In IV-Router Port, is the port used by the Interface Gateway when connecting to the IV-R.
Clear-Com recommends that you accept the default value of 6001 for the IV-Router Port.
Note:
If choosing an IV-Router Port other than 6001, refer to the Concert Installation Guide for
detailed guidance on modifying port usage.