Clear-Com HME DX210 - Manual (Page 20)

3.2 COMMUNICATOR
®
Operation
Belt Pack control buttons have a snap action. They will activate w
pressed firmly. Use your fingertips, not your fingernails, to press t
Belt Pack buttons. All-In-One Headset buttons are touch sensitive. hen
he
3.2.1 Power On/Off
PWR (power) button. A voice message in the earpiece will say
r
● ice message in the
nd the base station operator. Pressing
● Power On – Press and release the
“power on,” and the red power lights near the corners of the IC1 and IC2 buttons will go on. After a
short time, one light will go off and the other will change to green, indicating the Belt Pack is ready fo
use. The STATUS indicator on the base station will momentarily indicate the ID of the Belt Pack.
The green power light will be on steady whenever the Belt Pack is ready, but not transmitting.
NOTE: While the Belt Pack is transmitting, the green power light will be flashing.
Power Off – Press and hold the PWR button for approximately two seconds. A vo
earpiece will say “power off,” and the green power light will go off.
3.2.2 ISO (Isolate) and IC1, IC2 (Intercom)
Use the ISO button to talk to other wireless Communicator users a
ISO on the Belt Pack will also send audio to AUX OUT if the AUXILIARY OUT light on the front of the base
station is on. Use the IC1 and IC2 buttons to communicate via the wired intercom channels and the base
station operator. When the ISO button is pressed, ISO RELAY (#50) is activated.
3.2.3 Operating Modes
● Push-To-Talk ONLY Mode Operation – In PTT operation, audio is transmitted only while you are
pressing and holding the IC1, IC2 or ISO button. When you release the button, transmission stops.
● Hands-free Mode Operation – Quickly press and release the IC1, IC2 or ISO button to “latch” the
transmitter on. Talk and listen, as in a normal telephone conversation. Quickly press and release
the same button again to “unlatch,” and end the conversation. The base station operator can unlatch
all Communicators by pressing the UNLATCH button on the base station.
NOTE: In the hands-free mode, if you are latched in IC1, IC2 or ISO, quickly pressing/releasing
either of the other buttons will latch on that button.
Also in the hands-free mode, if you are latched in IC1 or IC2 and then press and hold the ISO button,
it will function as PTT. When you release the ISO button, the Communicator will revert to the latched
IC1 or IC2.
Refer to
Communicator indicator light functions, Appendix A, page 20 .
3.2.4 Volume Up/Down
● Volume Up Adjustment – Each time you press and release the volume-up ▲ button, a beep will be
heard in the earpiece as the volume increases one step. If you press and hold the volume-up button,
repeating beeps will be heard as the volume steps up to maximum. When maximum volume is
reached, “maximum “will be heard in the earpiece, and will be repeated until you release the volume-
up button.
● Volume Down Adjustment – Each time you press and release the volume-down ▼ button, a beep
will be heard in the earpiece as the volume decreases one step. If you press and hold the volume-
down button, repeating beeps will be heard as the volume steps down to minimum. When minimum
volume is reached, rapidly repeating beeps will be heard.
14 Clear-Com HME DX210 System Guide