Clear-Com HME DX210 - Manual (Page 13)

2.3 COMMUNICATOR
®
Setup and Registration 2.3 COMMUNICATOR
The first time you operate the DX210 system, you must register each Communicator (Belt Pack and/or
All-In-One Headset) for use with a specific base station. The base station will then recognize all
registered Communicators when their power is on, and will know the difference between them and other
electronic equipment operating on the same frequencies. If a Communicator is added or replaced later,
the new one must be registered and the old one remains in memory. A maximum of 15 Communicators
can be registered to a single base station at one time. The first time you operate the DX210 system, you must register each Communicator (Belt Pack and/or
All-In-One Headset) for use with a specific base station. The base station will then recognize all
registered Communicators when their power is on, and will know the difference between them and other
electronic equipment operating on the same frequencies. If a Communicator is added or replaced later,
the new one must be registered and the old one remains in memory. A maximum of 15 Communicators
can be registered to a single base station at one time.
2.3.1 Set Up COMMUNICATOR ® s 2.3.1 Set Up COMMUNICATOR
NOTE: If multiple base stations will be used, or if interference is present, such as Wi-Fi interference,
refer to
Base Station Registration and Interference Avoidance , in Appendix D and E, pages 23 and 25.
Before registering them, set up all Communicators as follows:
Before registering them, set up all Communicators as follows:
Belt Packs  Belt Packs 
1 1
2 2
3 3
Power
button Power
button
● 1 - Insert a fully charged battery
in each Belt Pack, with the
metal contacts on the end of
the battery inserted first.
Press it in until it snaps. ● 1 - Insert a fully charged battery
in each Belt Pack, with the
metal contacts on the end of
the battery inserted first.
Press it in until it snaps.
● 2 - Place each Belt Pack
in a pouch. ● 2 - Place each Belt Pack
in a pouch.
● 3 - Plug its headset cable
connector into each Belt Pack. ● 3 - Plug its headset cable
connector into each Belt Pack.
All-In-One Headsets  All-In-One Headsets 
Insert a fully charged battery in each Headset,
with the metal contacts on the end of the battery
inserted first. Press it in until it snaps.
Insert a fully charged battery in each Headset,
with the metal contacts on the end of the battery
inserted first. Press it in until it snaps.
7 Clear-Com HME DX210 System Guide
®
Setup and Registration
® s
NOTE: If multiple base stations will be used, or if interference is present, such as Wi-Fi interference,
refer to
Base Station Registration and Interference Avoidance , in Appendix D and E, pages 23 and 25.
Power
button
7 Clear-Com HME DX210 System Guide