Clear-Com HME DX210 - Manual (Page 15)

If you try to register more than 15 Communicators:
● An F will appear on the STATUS display on the base station and you will hear “Registration failed” in
the headset.
● Clear all current registrations by pressing the CLR/BND button and the RESET button at the same
time. To press the RESET button, insert a pen or similar pointed object into the RESET hole at the
lower-left corner of the base station front panel. Continue holding the CLR/BND button after you
release the RESET button, until the clear code “c” (lower case) appears on the STATUS display.
● Register all active Communicators, one at a time. Previously registered Communicators must be
re-registered.
2.3.3 COMMUNICATOR ® Settings
If you want to set up a Communicator with any of the special settings shown below, press and hold the
specified button combinations during or after power up. These settings will remain in memory when the
Communicators are turned off and on again.
For Setting Press & Hold while you Press & Release the Power button
ISO restrict on IC1 button
ISO restrict off IC1 ISO and buttons
Handsfree on selected button(s) IC1 and/or IC2 ISO and and/or ▲ volume up buttons
Handsfree off selected button(s) IC1 and/or IC2 and/or ISO and ▼ volume down buttons
Listen-Only mode on ▼ volume down button
Listen-Only mode off ▲ volume up button
WH210 only *
All-In-One Headset “lights-off” mode
IC2 button
* NOTE: All-In-One Headsets can be set up with its indicator lights off, to avoid distraction if users are in an area
visible to audience. This setting is not saved when you power off.
For Setting With the power already on - - -
Increase mic gain (15 steps) Press IC2 while you repeatedly press the ▲ volume up button
Decrease mic gain (15 steps) Press IC2 while you repeatedly press the ▼ volume down button
BP210 only *
Increase sidetone level (5 steps)
Press IC1 while you repeatedly press the ▲ volume up button
BP210 only *
Decrease sidetone level (5 steps)
Press IC1 while you repeatedly press the ▼ volume down button
* NOTE: There is no sidetone adjustment function for All-In-One Headsets.
Power
button
NOTE: If you are not connecting a wired intercom, go on to
System Operation, section 3, page 13.
9 Clear-Com HME DX210 System Guide