Clear-Com HME DX210 - Manual (Page 19)

3 System Operation
This chapter describes how to operate the Base Station and COMMUNICATOR ® (Belt Pack or
All-In-One Headset).
3.1 Base Station Operation
COMMUNICATOR ®
Registration
AUX IN Assign and
AUX In/Out Controls
Audio Channel and
Auto-Null Controls
Local Headset
Connnector & Controls
Power
Switch
3.1.1 Digital Radio Controls and Indicator Lights
● The CLR/BND button, RESET button,
STATUS indicator and REG button are
used when registering Communicators.
Refer to
Communicator registration
procedure, page 8 .
● The UNLATCH button is used by the base station operator to unlatch all Communicator transmitters.
● The RECEIVE IC1, IC2 (Intercoms) and ISO (Isolate) lights indicate whether reception from a
Communicator is on IC1, IC2 or ISO.
3.1.2 Local Headset Connector, Controls and Indicator Lights
● The SEL (select) button is used to select
communication from the local headset to IC1, IC2,
IC1 & IC2, or ISO.
● The IC1, IC2, IC1 & IC2, or ISO indicator light will be
● wireless users on the respective channel, as well as
●
●
e the TALK button quickly to “latch on.” To “latch off,”
ressing the TALK button. The
● Use the MIC LEVEL control to adjust the audio level from the local headset microphone.
lit for the selection you made.
IC1 and IC2 communication will be heard by
users wired into 2-W and 4-W connections.
ISO is heard in both wireless channels, and AUX OUT if activated.
NOTE: When the ISO button is pressed, ISO RELAY (#50) is activated.
The TALK button is used for communication from the local headset to the selected channel.
For open communication, press and releas
press and release the button again quickly.
For momentary communication, press and hold the TALK button for more than one second. In this
mode, the selected channel will remain open only as long as you are p
TALK light indicates the TALK mode is active via the local headset.
● Use the VOLUME control to adjust the output to the local headset earpiece.
13 Clear-Com HME DX210 System Guide