Installing interfaces in the median, Wiring remote devices to the matrix, Wiring panels to the matrix – Clear-Com LMC-64 User Manual
Page 98: Installing interfaces in the median -12, Wiring remote devices to the matrix -12, Wiring panels to the matrix -12
Clear-Com
Eclipse Median Instruction Manual
7 - 1 2
• The column of 16 green lights labeled “VOX” corresponds to the
card’s 16 ports. When lit, a “VOX” light indicates the audio level on
that port’s connected audio device has exceeded a threshold. The
threshold audio level is set for that port’s connected audio device in
the ECS application.
• The green “frame data” light illuminates green when information has
successfully passed between the CPU card and the port card.
• The red “status” light illuminates when the port card fails to
communicate with the CPU card.
INSTALLING INTERFACES IN THE MEDIAN
To install an interface card directly in the Median
1. Remove the blank plates from the front and rear of the interface slot
in which an interface card will be installed.
2. Install the front and back interface cards in the slot. Advance the
front card along the guides in the front part of the slot until the card
connects to the midplane connector. Advance the rear card along
the guides in the rear part of the slot, until it connects with the
midplane connector.
3. Install the provided screws on the front and rear panels of the
interface cards just installed, to secure the interface in place.
4. Repeat steps 1, 2, and 3 for each interface.
Note: One of the Median’s two power supplies will power all CPU,
port, and interface cards in the Median. The second power
supply provides backup power in case of outages. For more
information on installing and wiring a particular interface,
refer to that interface’s manual in the Eclipse set of
manuals.
WIRING REMOTE DEVICES TO THE MATRIX
The Eclipse Matrix Installation Manual (part 810298Z) gives complete
details about wiring remote devices to the matrix. The manual also
discusses RJ-45 cables and other types of cable required for system
installation.
The Eclipse Median system features two IEC mains AC power
connectors that provide separate power inputs for redundant power
supply combinations. If each AC input is connected to a different mains
AC branch, one power supply will continue to operate if the other
supply’s mains AC branch opens.
WIRING PANELS TO THE MATRIX
Eclipse uses a 4-pair (analog) or single-pair (digital) wiring scheme
between the matrix and panels. All Eclipse panels have built-in RJ-45
connectors.