Clear-Com LMC-64 - Manual (Page 29)

Clear-Com
Eclipse Median Instruction Manual 2 - 9
• Replace the master CPU card
System Status
If the “ENG” button only on the master CPU is pressed the following
system information will be displayed on the LED matrix:
• Eclipse release - "V5.2" at 5.2
• Eclipse IP address - IP address of the LAN 1 port. Example output
- "IP 169.254.000.100". If this address isn't statically allocated, but
instead was allocated via DHCP server this will be pre-pended by
"DHCP ENABLED".
• System Number - This is only output if the rack is part of a linked
set. It is the system number of the node within the linked set.
Example output - "SYSTEM 3"
• Software version Number - Version number of the config card
software. Example output - "RACK 1.0.2.1"
• Hardware Serial number - Example output- "SERIAL 2251" in the
case where the HW serial number is 2251.
FULL RESET BUTTON
When a full reset is performed all cards in the matrix reset regardless
of any system preferences in the program software and non-volatile
memory is cleared.
To perform a full reset
1. Press and hold the card’s lower RESET button (the “full reset”
button).
2. Simultaneously press and release the card’s upper RESET button.
3. Continue holding the card’s lower RESET button for two seconds.
The card performs a full reset.
The same configuration that was active before you reset the system
will be active after you reset it.
When the cards and connected audio devices reset, they momentarily
stop their current activity and restart. During this process configuration
information is downloaded to the cards and remote audio devices from
the CPU card’s non-volatile RAM.
Note: Under normal operating conditions it is not necessary to
perform a full reset. Technical personnel might perform a
full reset if they believe that the CPU card is operating
incorrectly as a result of corruption of the microprocessor’s
internal data or instruction sequence.
7