Clear-Com RS-603 (No longer available) - Manual (Page 7)

V - P A C K I N S T R U C T I O N M A N U A L
1 - 1
GETTING STARTED
WHAT IS V-PACK™?
With V-Pack™, you can create a custom setup of desired beltpack features on a
computer, and transfer the setup to a connected beltpack. The computer’s V-Pack
Windows interface becomes, in effect, a “virtual” beltpack, allowing you to
operate and program a connected beltpack remotely.
With V-Pack you can:
• Select and activate beltpack features in “real time.” As you select a feature on
the computer screen, it immediately goes into effect at the connected beltpack.
• Create up to four sets of features, called “modes,” to transfer to a connected
beltpack and store in its non-volatile memory.
• Select between the four setups with a beltpack’s onboard controls.When the
beltpack is disconnected from power, the custom setups remain in non-volatile
memory.
• Save setups to a computer file to upload to a beltpack in the future.
• “Clone” a custom setup for quick uploading to one or more beltpacks.
• Assign a unique identification code to a beltpack. You can then change the
identification code as needed.
• Quickly return a beltpack setup to the factory default setup by simply clicking
a button onscreen.
• Instruct beltpack to send a call signal automatically each time a talk button is
pressed
• Choose how a talk button latches—with a single or double tap; automatically
on power-up; continuously; or not at all.
• Select for use with an electret or dynamic mic-equipped headset.
• Adjust the headset microphone’s gain.
• Prevent headset levels from exceeding a maximum.
• Select between binaural and monaural operation on selected beltpacks.
• Lock-out onboard beltpack functions.
• And more features.
Two-channel belpacks add the following features:
• Send call signals as either 20 kHz AC, DC, or both.
• Program “listen-with-talk” on one or both channels.
• Set a minimum headset listen level.
With V-Pack™ software,
you can create, edit, and
store beltpack setup options
on a computer, and then
transfer the custom setups
to a connected beltpack..
You connect a beltpack to
the computer with a VPC-1
cable, available from
Clear-Com.
1