Burkert Type 8644 - Manual (Page 58)

58
Installation
NoTE!
The interface of the left connection module contains elements which may break off if force is used.
Never place the valve block on its sides and observe the permitted installation positions! •
Detach the module / terminals from the standard rail Figure 31:
installing the airline system (e.g. in the control 8.3.
cabinet)
NoTE!
Before installation, check that the fastening rail is anchored firmly in the control cabinet or in the system. •
Observe the specifications in the configuration file for the installation sequence. •
The valve block is not connected securely to the standard rail before the fastening screws are tightened.
During the entire installation ensure that it cannot fall down.
Connect all electrical modules/terminals on the left of the valve block to the standard rail according to the manu-
→
facturer’s specifications.
Slide the valve block onto the rail along the interface of the predecessor module.
→
Screw the valve block to the rail by tightening the fixing screws clockwise.
→
Mount all other modules / terminals on the standard rail.
→
Typ 8644
deutsch