Burkert Type 8644 - Manual (Page 56)

56
Installation
insTallaTiOn 8.
safety instructions 8.1.
DANgEr!
risk of injury from high pressure in the equipment!
Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines. •
risk of injury due to electrical shock!
Before reaching into the device or the equipment, • switch off the power supply and secure to prevent
reactivation!
Observe applicable accident prevention and safety regulations for electrical equipment! •
(Electronic modules and valves may also be replaced while the power supply is on)
WArNINg!
risk of injury from improper installation!
Installation may be carried out by authorized technicians only and with the appropriate tools! •
risk of injury from unintentional activation of the system and an uncontrolled restart!
Secure system from unintentional activation. •
Following installation, ensure a controlled restart. •
CAuTIoN!
escape of medium and malfunction!
If the seals are not seated correctly, leaks and malfunctions may occur due to pressure losses.
Ensure that the seals are seated correctly in the area of the electronics and pneumatics. •
short-circuit, malfunction
The electrical connection requires exact contacting.
Do not bend contacts. •
If connections are damaged or bent, replace the affected components. •
Do not switch on the system unless the components are in perfect condition. •
NoTE!
Operate the system with direct current only!
To prevent damage to the system, use only direct current for the system power supply.
prevent a pressure drop!
To prevent a pressure drop, design the system pressure supply with the largest possible volume.
Typ 8644
deutsch