Factory settings of the positioner, Installation, Safety instructions – Burkert Type 8694 User Manual
Page 11

11
Installation
6.8. Factory settings of the positioner
Functions can be activated via DIP switches:
Function
Parameter
Value
CUTOFF
Sealing function below
Sealing function above
2 %
98 %
CHARACT
Select characteristic
FREE
1)
DIR.CMD
Effective direction set-point
value
rise
Tab. 1: Factory settings - Functions
Additional functions are described in the operating instruc-
tions Type 8694 and in the communication software.
These instructions can be found on the Internet at
1)
without change to the settings via the communications software a linear
characteristic is stored in FREE.
7. INSTALLATION
Only for positioner without pre-assembled process valve.
7.1. Safety instructions
DANGER!
Risk of injury from high pressure!
• Before dismounting pneumatic lines and valves, turn off the
pressure and vent the lines.
Risk of electric shock!
• Before reaching into the device or the equipment, switch off the
power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations
for electrical equipment!
WARNING!
Risk of injury from improper installation!
• Installation may be carried out by authorized technicians only
and with the appropriate tools!
Risk of injury from unintentional activation of the system and
an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
english
Type 8694