Brooks Instrument QMBM User Manual
Page 35
Section 2 Installation
2-9
Installation and Operation Manual
X-CM-QmB-eng
Part Number: 541B029AAG
June, 2011
QmB Series IP40, IP66, IP66XP
2-10 Interconnection with Peripheral Equipment
Quantim Meter/Controller and Brooks Instrument Models 0152, 0154 or
0254 interconnection.
The following cables are available for connection of the Quantim Mass Flow
Meter/Controller to the Brooks Microprocessor Control & Read-out Unit:
Models # 0152, 0154 or 0254
Length: 3ft (1m);
part number
124Y054AAA
Length: 5ft (1.5m);
part number
124Y050AAA
Length: 10ft (3m);
part number
124Y051AAA
Length: 25ft (7m);
part number
124Y052AAA
Length: 50ft (15m);
part number
124Y053AAA
Or in case both Flow and Density or Temperature functions have to be
made available: (For 4-20 mA secondary output only)
Length: 5ft (1.5m);
part number
124Z906ZZZ
Length: 10ft (3m);
part number
124Z907ZZZ
Length: 25ft (7m);
part number
124Z908ZZZ
Length: 50ft (15m);
part number
124Z909ZZZ
The following open frame cables are available for connection of the
QUANTIM Mass Flow Meter/Controller to any secondary electronic device.
Length: 5ft (1.5m); part number 124Z361AAA
Length: 10ft (3m); part number 124Z362AAA
Length: 25ft (7m); part number 124Z363AAA
Length: 50ft (15m); part number 124Z435AAA
Length: 75ft (22m); part number 124Z876AAA
Length: 100ft (30m); part number 124Z868AAA
Length: 150ft (45m); part number 124Z757AAA
Length: 200ft (60m); part number 124Z773AAA
See Figure 2-7 for Wire Color Code Diagram
Cable Shielding Earth
Cable requirements:
Compliance with EMC directive 89/336/EEC, requires that the equipment
be fitted with fully screened signal cables with at least 80% shielding. The
cable shielding should be connected to the D-connector’s metal shell and
have 360° shielding at both ends. The shielding should be connected to an
earth terminal.