American Dryer Corp. ADS-464 II User Manual
Page 59
55
Circuit wiring; refer to ADS-464 main panel wiring diagram ADS-464 tumbler (basket)
junction box wiring diagram.
B. TUMBLER (BASKET) SECTION ELECTRICAL MALFUNCTIONS
INTRODUCTION
There are a number of electrical components associated with the ADS-464 tumbler (basket) section. These
components are ALL interfaced to the tumbler (basket) junction box, and connected to the main electrical
enclosure through a disconnect cable.
The tumbler (basket) junction box is located on the left side of the tumbler (basket), in the same area as the left
drum motor. The title of the wiring for the tumbler (basket) section is ADS-464 Tumbler (Basket) Electrical
Junction Box Wiring Diagram. The tumbler (basket) section electrical components provide:
Front and rear door position information
Drum rotation information
Rear panel controls for unloading
EMERGENCY STOP (E-Stop)
The tumbler (basket) junction box is located on the left side of the tumbler (basket) section, in the same area as
the left drum motor. The title of the wiring diagram for the tumbler (basket) section is ADS-464 Tumbler
(Basket) Electrical Junction Box Wiring Diagram. The tumbler (basket) section electrical components provide:
The following information will provide a means to respond to fault messages associated with the tumbler (basket)
section, and verify ALL the electrical signals associated with it.
Refer to the ADS-464 Tumbler (Basket) Junction Box Wiring Diagram for detailed wiring information.
1.0 Tumbler (Basket) Section Electrical Components
a. LOAD Door Switch - DS1
The LOAD door switch is located on the left side of the ADS-464 front doors and comprises of four (4)
parts: head, arm, body, and cord grip device. The head is a rotating type, with a spring arm attached for
switch actuation. The body contains a double pole, double throw, normally open switch. DS1 has two
(2) electrical functions, A and B.
b. UNLOAD Door Switch - DS2
The UNLOAD door switch is located on the right side of the ADS-464 rear doors and comprises of four
(4) parts: head, arm, body, and cord grip device. The head is a rotating type, with a spring arm attached
for switch actuation. The body contains a double pole, double throw, switch. DS2 has two (2) electrical
functions, A and B.
A provides rear door position signal to the PLC (Programmable Logic Controller).
B is a rear interlock to the burner controller circuit.