beautypg.com

American Dryer Corp. ADS-464 II User Manual

Page 14

background image

10

c. Reassemble The Tumbler (Basket) Section To The Tumbler (Basket) Base

Lift the tumbler (basket) section with a cable through the eye bolts on top of the section. Slowly lower the

tumbler (basket) section over the tumbler (basket) base. The four (4) large slots located on the bottom of

the tumbler (basket) section (one slot at each corner of the tumbler [basket] section) must be aligned

with the tapped holes in the cylinder cleaves located at the top of the tumbler (basket) section. Use the

four (4) 1-1/4-12 x 3-1/2” long bolts supplied with the unit to secure the tumbler (basket) section to the

tumbler (basket) base section.

d. Reattach The Control Pendant Arm

Position the control pendant arm on the top front of the heat console section by aligning the clearance

holes in the arm over the 1/4-20 tapped holes in the top of the heat console section. Use the 1/4-20 x 3”

long bolts supplied with the unit to attach the arm to the console.

e. Reconnect The Internal Air, Electric Connections, and Water Connections (refer to page 12 through

page 17).