American Dryer Corp. ADS-464 II - Manual (Page 37)

33
1) Front Panel Electrical Connections:
a) Front Position Switch Disconnect Plug;
The front door position switch disconnect plug is located on the left side of the front doors.
Disconnect this plug and feed the cable through the right hand side of the tumbler (basket)
section.
b) Intake Temperature Probe Disconnect Plug;
The intake temperature probe disconnect plug is located in the burner and heater section, just
above the 25 HP motor. Disconnect this plug and route through the hole located on the right of
the front panel.
2) Rear Panel Electrical Connection Plug;
a) Rear Panel Controls Disconnect Plug;
The rear panel controls disconnect plug is located behind the rear panel controls. Disconnect
this plug and feed through hole towards the left hand drum motor section.
b) Rear Door Position Switch Disconnect Plug;
The rear door position switch disconnect plug is located on the left side of the rear doors.
Disconnect this plug and feed the cable through the right hand side of the tumbler (basket)
section.
Put a block of wood under the tumbler (basket); loosen and back out the tumbler (basket) shaft
support bearings so that the drive wheel lines up with the large hole in the frame. The drive
wheel taper lock bushing can now be loosened and removed through the hole in the frame, and
the drive wheel pulled out of the dryer through this hole. Before backing out the tumbler (basket)
shaft bearings mark their position on the frame to make reassembly easier.
5. Tumbler (Basket) Retaining Wheels
There are eight (8) 4-7/16” (11.27 cm) diameter retaining wheels which stabilize the tumbler’s (basket’s)
position from front to back. Four (4) of these are mounted on the front panel of the dryer (two [2] on the left
side and two [2]) on the right side), and four (4) are mounted on the rear panel (two [2]) on the left side and
two [2] on the right side). Access to these wheels is obtained by removing the vertical front and rear panel
covers.