CEMB USA C206 (A) - Manual (Page 9)

I 0638 - 9
7
8
GB
5.1.2 - MANUAL SETTING
5.1.2.1 - STEEL WHEEL RIMS
- Preset distance of the inside of the wheel from the machine
- Preset the nominal diameter indicated on the tyre.
- Preset the nominal width which is normally stamped on the rim; if not,
measure dimension with the capelier gauge (supplied as standard)
Press to select the dimension to set and to modify it
5.1.2.2 - WHEEL ALUM
- Measure the dimensions as shown in the following diagram.
Note: if the outside diameter is not preset ( ) the system
automatically calculates the following:
outside diameter ( ) = inside diameter ( ) - 1".
14 mm car
20 mm truck
PRESETTING:
Press to select the dimension to set and to modify it
0 gauge