MoTeC PWC Plug-In ECU - Manual (Page 80)

MoTeC Appendices 73
AT4 B06 C08 via diode 10: Brake
Logic Polarity 1
Source 0
Channel 1
Lo Level 5.1
Hi Level 5.2
Note 2 – Calibration Tables
For the following pins the calibration table is available in the provided Base
Maps.
M400 Pin Hydro S4 Pin Function
AT1 B03 C20 Air Temperature
AT2 B04 C13 Engine Temperature
AV1 A14 C12 Throttle Position
AV2 A15 C11 Manifold Pressure Sensor
Note 3 – Speed
For accurate speed measurements, MoTeC recommends the use of a GPS
system.
MoTeC's 5 Hz GPS-G1 (#41300) can be wired directly into the ECU's RS232
receive port.
GPS wiring
M400 Pin GPS Pin Function
0V AUX B15 1 Bat –
RS232-RX B18 2 RS232 GPS Data
N/C 3
5V AUX
5V ENG A09
A02 4 5 V