MoTeC PWC Plug-In ECU - Manual (Page 58)

MoTeC Appendices
Note 2 – Calibration Tables
For the following pins the calibration table is available in the provided
Maps.
M400 Pin Kawasaki Pin Function
AT1 B03 K28 Air Temperature
AT3 B05 K03 Oil Pressure Switch
AV2 A15 K23 Manifold Pressure Sensor
AV3 A16 K11, F07 Engine Temperature
AV4 A17 K13, F06 Oil Temperature
AV5 A25 K08, F05 Intercooler Water Temperature
Note 3 – Speed
For accurate speed measurements, MoTeC recommends the use of a GPS
system.
MoTeC's 5 Hz GPS-G1 (#41300) can be wired directly into the ECU
receive port.
GPS wiring
M400 Pin GPS Pin Function
0V AUX B15 1 Bat –
RS232-RX B18 2 RS232 GPS Data
N/C 3
5V AUX
5V ENG A09
A02 4 5 V
51
For the following pins the calibration table is available in the provided Base
Intercooler Water Temperature
For accurate speed measurements, MoTeC recommends the use of a GPS
into the ECU's RS232