MoTeC PWC Plug-In ECU - Manual (Page 29)

22 Sea-Doo 2010 Installation
•
Now plug in the Adaptor Loom – first, Plug B into the stock wiring
harness, then Plug A.
•
Next plug the M400 ECU into the Adaptor Loom.
•
Ensure that all supplied devices are connected: M400, STC
IGN4, Relay. These devices can all be secured by zip
Warning – the M400 ECU MUST have
firmware version 3.52P or later loaded
BEFORE this Adaptor Loom is powered
up. If you have not loaded the firmware you
should unplug the IGN4 device and remove
all three of the injector/ignition fuses ( #7, 8,
and 9) from Fuse Box 1, and THEN load the
3.52P firmware.
Warning – the M400 ECU should have the
relevant start file installed before the IGN4
device and Injector/Ignition fuses are re
installed.
MoTeC
first, Plug B into the stock wiring
Ensure that all supplied devices are connected: M400, STC-SX,
These devices can all be secured by zip-ties.
the M400 ECU MUST have
firmware version 3.52P or later loaded
BEFORE this Adaptor Loom is powered
d the firmware you
should unplug the IGN4 device and remove
all three of the injector/ignition fuses ( #7, 8,
and 9) from Fuse Box 1, and THEN load the
the M400 ECU should have the
relevant start file installed before the IGN4
ice and Injector/Ignition fuses are re-