MoTeC PWC Plug-In ECU - Manual (Page 17)

10 Kawasaki Installation
The Ignition Module is fitted to the Ignition Mounting Plate.
Note: This module generates significant heat and requires the use of
dielectric grease between the module and mounting plate to ensure proper
heat transfer. Firm fixing of the mounting bolts is also necessary for proper
heat transfer.
The mounted module/plate assembly is placed on the underside of
the M400 mounting bolts, behind the ECU mounting bracket. Nylock nuts are
then used to secure the ignition assembly.
Due to the extra weight of the combined assembly there are 4 extra mounting
bolts and nuts supplied to bolt the factory plastic support bracket back into the
ski.
These bolts take the place of the plastic push lock clips that are used by
Kawasaki.
Output Test Function
To test if all outputs are correctly wired to the relevant injectors and coils, the
ECU Manager software has an output test function available. If you would like
to use this function in a Kawasaki installation refer to the notes in the
Appendices (
Output Test Function).
MoTeC
generates significant heat and requires the use of
dielectric grease between the module and mounting plate to ensure proper
heat transfer. Firm fixing of the mounting bolts is also necessary for proper
placed on the underside of
the M400 mounting bolts, behind the ECU mounting bracket. Nylock nuts are
Due to the extra weight of the combined assembly there are 4 extra mounting
factory plastic support bracket back into the
These bolts take the place of the plastic push lock clips that are used by
To test if all outputs are correctly wired to the relevant injectors and coils, the
ftware has an output test function available. If you would like
to use this function in a Kawasaki installation refer to the notes in the