MoTeC PWC Plug-In ECU - Manual (Page 38)

MoTeC Software Installation 31
Connecting the ECU to a PC
The PC communicates with the ECU via the CAN bus and connects to the
USB port on the PC.
This requires a MoTeC UTC (USB to CAN) device. The UTC plugs into the
CAN connector provided on the adaptor loom (5 pin connector) and includes a
standard USB cable to connect to the PC.
Note: Seadoo 2010 models have on-board CAN operating at 500kBit/Sec. To
communicate with a PC the ECU Manager Software must be set to the same
speed (see page 25 for details).
i2 Data Analysis Software
i2 data analysis software is used to analyse the logged data that has been
recorded by the ECU. A combination of graphs, gauges and reports can be
analysed simultaneously. The i2 environment can be customised to specific
user requirements.
The software can be downloaded for free from the website.
To install the i2 software
• Go to the MoTeC website at www.motec.com and navigate to
downloads/software/latestreleases
- OR -
Locate the software on the MoTeC Resource Disc.
• Save the selected file in your preferred location (for example desktop).
• When downloading is finished, double click on the file and select run.
• Follow the instructions on the InstallShield Wizard.
• To start the program after installation, click on the new i2 icon on the
desktop or click Start > All Programs > MoTeC > i2 Standard.
There are two levels of analysis functionality available; i2 Standard which is
included, and i2 Pro which requires the optional Pro Analysis upgrade.
See Upgrades for more information.