MoTeC PWC Plug-In ECU - Manual (Page 73)

66 Appendices
Calibration and Wiring Notes
Note 1 – Calibration Functions
The following pins are calibrated in the Base Maps with the function and
parameters as mentioned in the table.
M400 Pin Sea-Doo Pin Function Parameters
Aux1 A18 A-L2 5: Drive by Wire
Aux2 A01 A-L1 0: Off
Aux3 A23 B-E4, B-H2 0: Off
Aux4 A24 B-L4 115: Status Selection 40
Logic Polarity 0
Output Mode 0
Flash 0
Flash Rate 0.0
Aux5 A31 L04 9: Lambda Heater Lambda Sensor 1
Aux6 A32 R86 101: Fuel Pump Delay 3.0
Polarity 1
Output Mode 1
Aux7 A33 0: Off
Aux8 A34 0: Off
AT6 B19 B-D1 31: Start/Stop
Switch Polarity 1
Stop Delay 0.2
Setup - Lo Level 5.2
Setup - Hi Level 5.3
Note 2 – Calibration Tables
For the following pins the calibration table is available in the provided
Maps.
M400 Pin Sea-Doo Pin Function
AT1 B03 A-H3 Air Temperature
AT2 B04 A-A1 Engine Temperature
MoTeC
with the function and
Parameters
Selection 40
Logic Polarity 0
Output Mode 0
Flash Rate 0.0
Lambda Sensor 1
Polarity 1
Output Mode 1
Polarity 1
Stop Delay 0.2
Lo Level 5.2
Hi Level 5.3
For the following pins the calibration table is available in the provided Base