Appendix j – analog output wiring, 44 appendices, Floating measuring device – MoTeC PLM User Manual
Page 44: Single ended input measuring device, Differential input measuring device
44
Appendices
Appendix J – Analog Output Wiring
Floating Measuring Device
When connected to a floating measuring device such as a multimeter, Aout–
should be connected to Battery– as shown to ensure that the full output voltage
swing is available. (See the specifications for details)
F8
F9
PLM
Floating
Measuring Device
Input +
Input –
(0V)
A out +
A out -
M6
Battery-
Battery-
Single Ended Input Measuring Device
A single ended measuring device has the negative input internally connected to
the devices ground pin.
Note: The Ground voltage must not be more than 4.5 volts below Battery–.
Note: If the Ground voltage is greater than the Battery – voltage then the PLM
output voltage swing will be reduced. (See the specifications for details)
F8
F9
PLM
Single Ended
Measuring Device
Input +
Input -
A out +
A out -
M6
Ground
Ground
Battery-
Battery-
Differential Input Measuring Device
When connected to a differential input measuring device, Aout– should be
connected to Battery– as shown to ensure that the full output voltage swing is
available. (See the specifications for details)