MoTeC PLM User Manual

Page 35

Text mode
Original mode

MoTeC

Appendices

Note 3: Wiring

See Appendix G – PLM to ADL Wiring Details for CAN wiring to an ADL

See Appendix F – PLM to ECU Wiring Details for CAN wiring to an M800 ECU

See Appendix H – General CAN Bus Wiring for recommended CAN wiring
practices

Note 4: Analog Output

Connect the “Analog out +” to the input on the measuring device.

Connect the “Analog out –“ to the 0V reference point on the measuring device.
“Analog out –“ must be connected for the measuring device to make a correct
reading.

See Appendix F – PLM to ECU Wiring Details for wiring the analog outputs to
M4/M48, M8 & M800 ECUs