MoTeC M880 - Manual (Page 73)

MoTeC ECU Manager Software 71
Copy Table from Another File
Copy a table from another calibration file into the current table.
Warning - The current table data will be overwritten.
Import CSV File
Read a CSV (Comma Separated Value) file into the current calibration table.
Normally the CSV file is one that has been written out from another
configuration file, possibly for a different ECU type.
Warning - The current table data will be overwritten.
Note that the CSV file must be for the same type of table.
Note also that the site values are not imported therefore the site values must
be the same as the sites in the CSV file for the table to have the same result.
Export CSV File
Write the current table to a CSV (Comma Separated Value) file.
May be used to transfer data between different ECU types or for use in a
spreadsheet.
Insert Site
Insert a site to the left of the current site.
The new site value will be half way between the value of the current site the
value of the site to the left.
(Available only in the Site setup screens)
Delete Site
Delete the current site.
(Available only in the Site setup screens)