MoTeC M880 - Manual (Page 70)

68 ECU Manager Software
The comparison file may be selected by choosing Select Compare File from
the Tools menu.
When Compare Mode is turned on an icon will appear at the left of the Adjust
Menu items that contain differences.
Select Compare File
Selects the file used for Compare Mode.
Jump to Site
Moves the Cursor block to the Site closest to the current engine operating
point.
Quick Lambda
Adjusts the fuel value to achieve the lambda value in the Wideband Lambda
table. The Lambda Table may be accessed from the Functions | Lambda
Control menu or by pressing the F8 key.
The new fuel value is calculated by checking the difference between the
Lambda sensor reading and the value in the Wideband Lambda Table.
The Lambda reading may be either Lambda 1, Lambda 2 or the Average of
both, this is configured in the Wideband Lambda setup.
The engine must be operating near the centre of the site for the calculation to
give correct results.
Quick Lambda may be used from the Fuel Main Table, Fuel Injection Timing
Table, Ignition Main Table, Fuel Second Load Table & Fuel Individual Tables.
When used from the Fuel Main Table the cursor jumps to the closest site if
the cursor is not on site.
When used from the Ignition main Table or Fuel Injection Timing Table the
Fuel Main Table site closest to the current operating point is adjusted.
When used from the Fuel Second Load Table or the Fuel Individual Tables
the change is made to that table rather than the Fuel Main Table.
Quick Lambda + Copy Up & Right
As for Quick Lambda except that the new value is copied to the sites
immediately above, right and diagonally above and right if the sites do not
contain a *.