B&K Precision 4084-4087 - Manual - Manual (Page 44)

4080 series Function & Arbitrary/Function Generators –Instruction Manual
44
PSKey:PHASe2
Set phase 2 of PSK in 0--360º.
PSKey:PHASe2?
Check phase 2 of PSK.
PSKey:INTernal:SPACe
Set time interval of phase switching
PSKey:INTernal:SPACe?
Check time interval of phase switching
PSKey: SOURce {INTernal|EXTernal}
Set trigger source of PSK as internal (INTernal) or external (EXTernal).
PSKey:SOURce?
Check current trigger source of PSK.
PSKey:STATe {ON|OFF}
Turn on PSK mode (ON) or turn of f PSK mode (OFF).
PSKey:STATe?
Check the “on/off” state of PSK mode. The returned data are “0” (OFF) or “1” (ON). It returns to
fixed frequency mode in “off” state.
Sweep Mode instructions
1.
To set the output waveform, amplitude, DC offset and frequency using APPLy instructions or
FUNCtion, FREQuency, VOLTage, VOLTAGE:OFFSet instructions.
2. To set start frequency of sweep using FREQuency: STARt instruction.
3. To set stop frequency of sweep using P FREQuency: STOP instruction.
4. To set sweep mode using SWEep: SPACing {LINear|LOGarithmic} instruction.
5. To set sweep time using SWEep: TIME instructions.
6. To set trigger source of sweep using SWEep: SOURce {INTernal|EXTernal}instructions.
7. To turn on sweep using SWEep: STATe ON instruction.
FREQuency:STARt
Set start frequency of sweep.
FREQuency:STARt?
Check startting frequency of sweep.
FREQuency:STOP
Set stop frequency of sweep.
FREQuency:STOP?
Check stop frequency of sweep.
SWEep:SPACing {LINear|LOGarithmic}
Set sweep mode as linear (LINear) or logarithmic (LOGarithmic)
SWEep:SPACing?
Check sweep mode.
SWEep:TIME
Set sweep time.
SWEep:TIME?