AVTECH Room Alert 3E Monitor (RA3E-ES0-BAS) - Manual (Page 33)

Room Alert 3E
AVTECH Software, Inc. 29
Temperature Scale Configuration
You may select the default temperature scale for your Room Alert 3E here.
1. Select Fahrenheit or Celcius .
2. Click Accept Changes at the bottom of your screen.
3. Click Save Settings in the navigation bar to the left of your screen.
Status Page Configuration
You may set defaults for the “Status” screen here.
1. In “Refresh Rate (seconds),” enter the number of seconds you would like the “Status”
screen to refresh at. You may enter a value from 1 to 65535. The default is 60 seconds
(i.e., every 1 minute).
2. In “HTTP Port,” you may change the port number your web browser uses to connect to
your Room Alert’s web interface. It uses port 80 by default.
3. Click Accept Changes at the bottom of your screen.
4. Click Save Settings in the navigation bar to the left of your screen.
Device ManageR Push Configuration
By default, Device ManageR queries your Room Alert 3E for sensor values at defined intervals.
However, you may configure your Room Alert 3E to proactively send sensor updates to Device
ManageR by enabling “Device ManageR Push.”
Enabling “Device ManageR Push” is an advantage for two reasons:
• Your Room Alert 3E can communicate with Device ManageR without triggering any
firewalls between the two. Firewalls typically allow out-going connections while
blocking in-coming connections.