AVTECH Room Alert 3E Monitor (RA3E-ES0-BAS) User Manual
Page 23
Room Alert 3E
AVTECH Software, Inc.
19
SNMP Trap Sending Configuration
You may configure your Room Alert 3E to send SNMP Traps in response to a change in alarm
state to up to three host systems running 3
rd
-party SNMP monitoring applications. Each host
system you enter in these fields will receive the same SNMP Traps simultaneously.
To configure your Room Alert to send SNMP Traps:
1. In “Trap Send IP 1,” enter the IP address of the host system that runs your 3
rd
-party
SNMP monitoring application.
2. In “Trap Sent IP 2” and “Trap Send IP 3,” you may enter the IP addresses of other host
systems that run 3
rd
-party SNMP monitoring applications, or leave the default, 0.0.0.
3. Click
Accept Changes
at the bottom of your screen.
4. Click
Save Settings
in the navigation bar to the left of your screen.
Sensors
You may configure alert thresholds for the internal temperature, external digital and external
switch sensor connected to your Room Alert 3E in this screen. Your Room Alert 3E sends alerts
in response to changes in these alert thresholds.
For more information about AVTECH sensors and accessories,
please refer to the
Appendix
at the back of this manual or visit the
Sensors and Accessories sections of
AVTECH.com
.
NOTE