Atec Rohde-Schwarz-ESRP Series - Manual (Page 13)

Version 01.01, January 2013
Rohde & Schwarz R&S ® ESRP EMI Test Receiver 13
Inputs and outputs
RF input
Impedance
50 Ω
Connector N female
VSWR RF attenuation ≥ 10 dB, DC coupled
10 Hz ≤ f ≤ 1 GHz < 1.2
1 GHz < f < 3.6 GHz < 1.5, 1.3 typ.
3.6 GHz ≤ f ≤ 7 GHz < 2, 1.8 typ.
RF attenuation < 10 dB, DC coupled
10 Hz ≤ f ≤ 1 GHz <2
1 GHz < f ≤ 7 GHz <3
RF attenuation ≥ 10 dB, AC coupled
10 MHz ≤ f ≤ 1 GHz < 1.2
1 GHz < f < 3.6 GHz < 1.5, 1.3 typ.
3.6 GHz ≤ f ≤ 7 GHz < 2, 1.8 typ.
Setting range of attenuator 0 dB to +70 dB, in 10 dB steps
Probe power supply
Supply voltages
3-pin connector +15 V DC, –12.6 V DC and ground,
max. 150 mA (nom.)
5-pin connector ±10 V DC and ground, max. 100 mA,
(nom.)
Noise source drive
Connector
BNC female
Output voltage 0 V/28 V, max. 100 mA, switchable (nom.)
AF output
Connector
3.5 mm mini jack
Output impedance 10 Ω (nom.)
Open-circuit voltage up to 1.5 V, adjustable
USB interface front panel 2 ports, type A plug, version 2.0
rear panel 2 ports, type A plug, version 2.0
Reference output
Connector
BNC female
Impedance 50 Ω (nom.)
Output frequency internal reference 10 MHz
external reference same as reference input signal
Level > 0 dBm (nom.)
Reference input
Connector
BNC female
Impedance 50 Ω (nom.)
Input frequency range 1 MHz ≤ f
in
≤ 20 MHz, in 100 kHz steps
Required level > 0 dBm into 50 Ω (nom.)
External trigger/gate input
Connector
BNC female
Trigger voltage 0.5 V to 3.5 V (nom.)
Input impedance 10 kΩ (nom.)
IEC/IEEE bus control interface in line with IEC 625-2
(IEEE 488.2)
Command set SCPI 1997.0
Connector 24-pin Amphenol female
Interface functions SH1, AH1, T6, L4, SR1, RL1, PP1, DC1,
DT1, C0